Programmable Logic Controller MCQ Quiz Test No.: 11

15
Created on By Prof. Dhruv Patel

MCQ Quiz – Test: 11 : Programmable Logic Controller

This quiz helps students to increase their Programmable Logic Controller knowledge.

1 / 10

For less than counter,

2 / 10

A one-shot, or transitional, contact

3 / 10

Normally counters are retentive. This means that if your accumulated count value is increasing and suddenly system power lost when accumulated value is 500. When power is restored the accumulated count will be

4 / 10

When the up-counter reset is set to true, the following happens

5 / 10

For Angle measurement of D.C. Motor shaft using PLC, which instruction is used

6 / 10

For measuring the bidirectional speed of D.C.motor (with Encoder) using PLC, which instruction is used

7 / 10

For calculating speed of d.c motor using PLC, which instruction is used

8 / 10

For calculating Encoder pulses using PLC, which instruction is used

9 / 10

For calculating fast speed pulses using PLC, which instruction is used

10 / 10

Which of the following is not usually associated with a PLC counter instruction?

Your score is

The average score is 26%

LinkedIn Facebook Twitter VKontakte
0%

Test No. 1

Test No. 2

Test No. 3

Test No. 4

Test No. 5

Test No. 6

Test No. 7

Test No. 8

Test No. 9

Test No. 10

Test No. 11